New method to find right tilt angle for PV systems located in high-latitude, cold regions – pv magazine International

March 19, 2024 Lior Kahana

Scientists from Sweden have developed a novel model for optimal PV installation angles in cold high-latitude regions. The model uses weather big data and also accounts for the effect of transmittance change caused by snow, which is calculated by taking into account snow depth, as well as its melting rate.

“Snow-induced loss might be a small proportion for low/mid latitude,” the researchers said. “However, for the high-latitude areas where the winter seasons are generally lengthy, the snow effects play an important role so that exclusion of snow effects would significantly influence the reliability of the results.”

The novel method couples an optimal PV installation angle model to maximize PV power generation with a simplified snow-PV yield model (SPYM). The PV angle model is executed with angles ranging from 0 degrees to 90 degrees with 0.1-degree intervals, finding the optimal position based on total global solar irradiation on the PV system, which is given by the sum of direct, diffuse, and reflection irradiation.

The adjusted irradiation is yielded from the SPYM model, which is based on snow depth, air temperature, and irradiation. While the temperature can predict whether the snow on the panel is melting or covering the module, the snow depth determines its transmittance.

“The calculation of this snow loss factor refers to the transmittance model from Perovich,” the academics said. “The transmittance drops sharply from 1 to 0.1 when snow depth increases from 0 to 2 cm. Then, the decrease becomes smoother, and the value reaches 0.01 when the snow depth increases to 12 cm. When the snow depth is thicker than 12 cm, the value is assumed to be 0.”

PV generation reduction due to snow
” data-medium-file=”https://www.pv-magazine.com/wp-content/uploads/2024/03/1-s2.0-S0306261924000734-gr7_lrg-600×201.jpg” data-large-file=”https://www.pv-magazine.com/wp-content/uploads/2024/03/1-s2.0-S0306261924000734-gr7_lrg-1200×401.jpg” class=”size-medium wp-image-248809″ src=”https://www.pv-magazine.com/wp-content/uploads/2024/03/1-s2.0-S0306261924000734-gr7_lrg-600×201.jpg” alt width=”600″ height=”201″ srcset=”https://www.pv-magazine.com/wp-content/uploads/2024/03/1-s2.0-S0306261924000734-gr7_lrg-600×201.jpg 600w, https://www.pv-magazine.com/wp-content/uploads/2024/03/1-s2.0-S0306261924000734-gr7_lrg-1200×401.jpg 1200w, https://www.pv-magazine.com/wp-content/uploads/2024/03/1-s2.0-S0306261924000734-gr7_lrg-768×257.jpg 768w, https://www.pv-magazine.com/wp-content/uploads/2024/03/1-s2.0-S0306261924000734-gr7_lrg-1536×514.jpg 1536w, https://www.pv-magazine.com/wp-content/uploads/2024/03/1-s2.0-S0306261924000734-gr7_lrg-2048×685.jpg 2048w” sizes=”(max-width: 600px) 100vw, 600px”>

Following the development of the model, the scientists used Solcast historical meteorological data for 2012-2021 for the Swedish city of Hammarby Sjöstad as input. Optimal calculations were made for one year, five years, and ten years. In their case study, they assumed PV modules with 19.2% efficiency and an output of 430 MW.

Then, they compared and used their novel model for three scenarios. The first case was a base case with no snow conditions, considering only historical irradiation and temperature data. In the second scenario, snow effects were calculated with the assumption that it melts after 12 hours. The last scenario assumed removal agents, which shortened the snow removal time to one hour. All the results were compared to the commercial insulation angle of 15 degrees and the geometric angle for Sweden, 40.7 degrees.

“The PV system with the annual optimal angle outperforms the one with a commercial angle, resulting in an approximate 4.8% increase in power generation,” the research group stated. “The optimal PV installation angle decreases when considering snow conditions, with the difference dependent on local weather conditions each year, reaching up to 7.8 degrees.”

In addition, the scientific group found that snow conditions lowered power generation conditions by 14.7%. They also found that applying removal agents can improve PV performance by 0.1%–2.3%.

Their findings were presented in “A new optimal PV installation angle model in high-latitude cold regions based on historical weather big data,” published on Applied Energy. The research was conducted by academics from Sweden’s KTH Royal Institute of Technology and the Swedish Meteorological and Hydrological Institute.